Differences

This shows you the differences between two versions of the page.

--- 04_projects:01_clock [2024/07/30 16:56] – [Preparing the Gear Shafts] jattie
+++ 04_projects:01_clock [2024/08/01 15:15] (current) – [Installing gear shafts] jattie
@@ Line 230: / Line 230: @@
 ==== Installing gear shafts ====
-Proceed to print the various gear assemblies and install the gear shafts by tapping gently with a hammer on a flat surface with a hole through and measure the shafts for the correct protrusion distances as shown below.
+Once the shafts are cut to length and cleaned up, proceed to print the various gear assemblies and install the gear shafts by tapping gently with a hammer on a flat surface with a hole through and measure the shafts for the correct protrusion distances as shown below.
 {{ :04_projects:screenshot_2024-07-30_172411.png?nolink |}}
+{{ :04_projects:screenshot_2024-07-30_195804.png?nolink |}}
+{{ :04_projects:screenshot_2024-07-29_182135.png?nolink |}}
 ===== Assembly Rods =====
@@ Line 240: / Line 242: @@
 {{ :04_projects:screenshot_2024-07-29_183215.png?nolink |}}
-{{ :04_projects:screenshot_2024-07-29_183201.png?nolink |}}
-{{ :04_projects:screenshot_2024-07-29_182135.png?nolink |}}
 ===== References =====