Differences

This shows you the differences between two versions of the page.

--- 04_projects:01_clock [2024/07/30 16:40] – [Pendulum Clock Design] jattie
+++ 04_projects:01_clock [2024/08/01 15:15] (current) – [Installing gear shafts] jattie
@@ Line 1: / Line 1: @@
-~~CLOSETOC~~
+~~TOC~~
 |<100% 25% - >|
 ^  \\ 3D PRINTING AND DESIGN REFERENCE DOCUMENT\\ \\   ^^
@@ Line 18: / Line 18: @@
 ====== Pendulum Clock Design ======
+This document is not completed yet, it is a work in progress with updates added as the build process progresses.
+The first part of the document discusses the design process and the second part [[04_projects:01_clock#parts_printing_and_assembly|the build process]].
 ===== Background =====
@@ Line 190: / Line 196: @@
 ===== Preparing the Gear Shafts =====
+The gear shafts are cut from any 4mm round rod material. I had some 4mm steel wire and searched for 4mm bearings to go with that.
 {{ :04_projects:screenshot_2024-07-30_095731.png?nolink |}}
@@ Line 222: / Line 230: @@
 ==== Installing gear shafts ====
-Proceed to print the various gear assemblies and install the gear shafts by tapping gently with a hammer on a flat surface with a hole through and measure the shafts for the correct protrusion distances as shown below.
+Once the shafts are cut to length and cleaned up, proceed to print the various gear assemblies and install the gear shafts by tapping gently with a hammer on a flat surface with a hole through and measure the shafts for the correct protrusion distances as shown below.
 {{ :04_projects:screenshot_2024-07-30_172411.png?nolink |}}
+{{ :04_projects:screenshot_2024-07-30_195804.png?nolink |}}
+{{ :04_projects:screenshot_2024-07-29_182135.png?nolink |}}
 ===== Assembly Rods =====
@@ Line 232: / Line 242: @@
 {{ :04_projects:screenshot_2024-07-29_183215.png?nolink |}}
-{{ :04_projects:screenshot_2024-07-29_183201.png?nolink |}}
-{{ :04_projects:screenshot_2024-07-29_182135.png?nolink |}}
 ===== References =====